How much HP does a cammed 5.3 make?
How much HP does a cammed 5.3 make?
Equipped with the hot rod factory cam, the Strictly Performance 5.3L produced 428 hp at 6,200 rpm and 399.9 lb-ft of torque at 5,000 rpm.
How much does it cost to get a Silverado cammed?
between $600 and $1,000
Assuming you provide your own new camshaft, most shops will charge between $600 and $1,000 to cam your truck.
How long does an LS cam swap take?
Torque the oil pump bolts to their spec and you’re ready to move on. The swap is easy and on the dyno, we’ve accomplished this entire process in under 30 minutes with only a couple of specialty tools that aren’t expensive and we didn’t even work up a sweat. This is just one more reason the LS engines are so popular.
How much HP can a stock 5.3 take?
If we were to run the 5.3L in stock trim, the resulting power output would be around 360 hp (on this dyno, the way we test). If we apply 14.7 psi from our turbos to the stock 360hp motor, we might get 720 hp.
How much HP does a cam add?
A quality camshaft can increase your car’s horsepower by 10 to 20 times, depending on the camshaft you opt for.
Does camming a car make it faster?
Performance cams increase the duration and timing of the valve openings during the engine stroke, increasing horsepower and making your car accelerate more quickly. You’ll idle slightly rougher with a performance cam, but get a throaty rumble that’s desirable for some gearheads, depending on your vehicle.
Do I need a tune after a cam swap?
Most entry level blowers will be as reliable as a cam swap on an otherwise unmodified motor. After your new cam is installed, you will need a custom tune to ensure your vehicle is calibrated for your new parts.
Does a cam add horsepower?
Does a camshaft increase horsepower? Yes, a camshaft adds 10 to 20 horsepower depending on the setup. To get the full potential of the high-performance camshaft, you’ll have to swap out additional components like the air intake, exhaust manifold, injectors, and valve heads.
Can you change a cam without pulling the motor?
Yes, but just. Obviously you’ll have to remove the distributor, lifters, oil pan, pulies, damper and timing chain and cover. You’ll have to remove the rad and possibly the rad support too. Some folks have had to loosen their engine mounts and jack it up a little or raise the transmission to get clearance .
How much hp can a stock 5.3 take?
Can you stroke a 5.3 LS?
One of the easiest and most affordable stroker LS engine combos you can build is a simple 383 that combines a 3.905- inch bore and a 4.000-inch stroke. This can be achieved with either a 5.7L LS1 block or a 5.3L iron unit.
How much HP can a stock bottom end 5.3 hold?
If we were to run the 5.3L in stock trim, the resulting power output would be around 360 hp (on this dyno, the way we test).
What is a Stage 3 cam?
The Stage 3 LS1 camshaft is the largest camshaft that we recommend with the stock torque converter. This Cam Motion hydraulic roller cam delivers mild performance idle, excellent low end torque, and extended RPM capabilities over the stock camshaft.
How much hp does a Stage 1 cam add?
While it’s true that camshaft adds horsepower, it’s only 10-20 horsepower and generally less than a 10% increase. The often-quoted 50-100 horsepower gain is only possible with a series of accompanying modifications through Stage 1 and Stage 2 mods.
How much HP can a cam add?