What is engine oil control valve?

What is engine oil control valve?

The Oil Control Valve (OCV) is a a critical part used in every engine that is fitted with variable valve technology (VVT). A single control valve will regulate the supply of oil to a designated VVT hub, to advance or retard the timing by altering the camshaft angle position.

How much does it cost to replace oil control valve?

The replacement cost of an oil control valve can be as high as $350. The price of the parts is between $100 and $200, while the cost of labor is between $80 and 160.

How do you know if your oil control valve is bad?

If you have oil control valve problems, then there are certain symptoms you can look out for. Some of them include slow acceleration, poor brake performance, and a strange burning smell in the car. Before it gets this bad, the computer in your vehicle should give you some warnings first on the dashboard.

How do I know if my VVT is working?

Common signs include a rough engine idle, the Check Engine Light coming on, and the engine stumbling when climbing hills or under load.

What happens when solenoid valve goes bad?

The most common symptom of a bad VVT solenoid or oil control valve is a check engine light on your dashboard. You may also notice issues with the performance like rough idle, rough acceleration, increased fuel consumption, or low engine power.

Can you drive with a bad oil solenoid?

Can You Drive with a Bad VVT Solenoid? Even though you may technically be able to continue driving with a bad VVT solenoid, the issue can cause damage to additional parts, such as the VVT actuator. So, you should address the issue as soon as possible.

How do you know if your valve timing is off?

What happens if valve timing is incorrect?

If the valve timing is incorrect, not only will the engine not run, but the piston could smash into the valves, causing catastrophic damage. Usually, the result is bent valves and damaged pistons.

How do I know if my solenoid valve is not working?

Solenoid Valve fails to open. Check if valve is normally closed (power to open) Or Normally Open (Power to close) Use magnetic detector lift coil slightly to check if magnetic field is present.Do not remove coil if energised as IT WILL BURN OUT Check contacts Check wire connections and DIN connector. Check fuses.

What happens if solenoid valve is not working?

Solenoid coil failure can be caused by a number of factors. Applying an incorrect voltage to the coil will cause it to fail and may cause the coil to burn out. Electrical surges or spikes may also damage the coil. Burnt out coils cannot be repaired and will need to be replaced.

How do I know if my valves are out of adjustment?

When do I need to have a valve adjustment? You should have your valve lash inspected at manufacturers recommended intervals. A sure sign that it’s time for a valve lash adjustment is if your engine is making a loud clicking or tapping noise when starting up or if you experience a loss in engine power.