Darkskiesfilm.com

explore the world through the prism of knowledge

General 

What does the mode button do on Cisco switch?

Admin 0 Comments

What does the mode button do on Cisco switch?

Mode Button is used in combination with the port LED’s for checking the status of ports. It is also used to check the utilization on the switch etc. However, they are not the easiest of indicators to remember. So, Its most useful feature is about password recovery of the Enable mode Passwords.

What is the default password for a Cisco 2960?

cisco
When prompted, enter the default password, cisco.

Where is Mode button?

The MODE button (see the image below) is the left one of the two buttons between the mode dial and the command dial.

What is the mode button?

The MODE button is used for three main functions: press the “Mode” button ONCE for checking how many days the monitor has measured Radon since the last time it was turned on/reset; press the “Mode” button TWICE for gathering the 4-digit code you need in order to generate a report.

How do I reset my cisco Catalyst 2960 password?

Find the below steps to recovery password for Cisco 2960.

  1. Power off the switch first, then press and hold the mode button while you power on the switch again.
  2. To initialize the flash file system, run the command:
  3. You can now list the contents of your flash by running.
  4. To further boot the switch run the boot command as:

What is the default IP for Cisco Catalyst 2960?

10.0.0.1
The BASIC CONFIGURATION window appears. The switch has a default IP address “10.0. 0.1” and a secondary IP address “10.0. 0.3”.

How do I reset my 2960 to factory settings?

Reset a Cisco 2960 Switch to Factory Default Settings

  1. – Start by connecting your cisco switch via a console cable that will be also connected to the same console.
  2. Step 2.- Use the following commands: Router: en. Router#erase startup-config. Router# del flash:vlan.dat.
  3. – Reload your cisco switch to complete the restoration.

How do I connect a Cisco switch to my computer via console?

Plug the serial DB9 end of the console cable into your computer’s serial port and connect the RJ45 end on the Cisco Switch. But if your computer does not have a serial DB-9 port, connect the serial DB9 console cable end into the Serial-to-USB adapter and then plug it into your laptop.

What are the steps to configure a switch?

How to configure a network switch

  1. Step 1: Connect to the console.
  2. Step 2: Set a management IP and default gateway.
  3. Step 3: Set hostname and domain name.
  4. Step 4: Set logins on VTY lines and console port.
  5. Step 5: Set Privileged EXEC password.
  6. Step 6: Enable SSH.
  7. Step 7: Create VLANs.
  8. Step 8: Add access ports to a VLAN.

What is the Dial button?

The speed dial on the telephone allows a person to call a specific telephone number with just the push of a button. Speed dialing has the advantage of users not having to remember long telephone numbers and enter the long telephone number into their phones.