What did Roger Tsien discover?
What did Roger Tsien discover?
Tsien contributed to the fields of cell biology and neurobiology by discovering genetically programmable fluorescent tags, thereby allowing scientists to watch the behavior of molecules in living cells in real time.
Does ERV provide make up air?
An ERV supplies continuous fresh air throughout the house with its own ducts and it exhausts indoor air at the same rate, for balanced ventilation. Range hoods provide relatively powerful spot ventilation when needed, but do not replace that air; they are an exhaust-only appliance.
How is GFP produced?
Green fluorescent protein (GFP) is a protein produced by the jellyfish Aequorea victoria, that emits bioluminescence in the green zone of the visible spectrum. The GFP gene has been cloned and is used in molecular biology as a marker.
Should I run my ERV continuously?
To maintain air quality set the ERV controls to the intermittent on off cycle. This continuous intermittent setting should be maintained all year round. If you have a party or are cooking food with odours you can turn the control to high for an hour or so.
Should ERV run all the time?
If you’re inside, it’s better for air to be ventilating all the time. The ERV fan can run all the time, providing more consistent ventilation. Efficiency: Compared to an HVAC blower fan, your ERV’s fan is less expensive to operate.
What is the size of GFP?
GFP is a 28 kDa protein that resembles a cylinder with a length of 4.2 nm and a diameter of about 2.4 nm (Hink et al., 2000). The complete beta-barrel is necessary for its fluorescence and therefore GFP cannot be downsized by deleting residues.
Should I turn off ERV in summer?
Don’t run the ERV in summer as it will create humidity. The ERV contains an Energy Recovery Core (made of polymerized paper and aluminum) that decreases the humidity of incoming air in the summer by up to 60%. (This Recovery Core acts like a membrane moving humidity for the incoming air to the outgoing air.)
What should I set my ERV at?
A typical ERV, though, can move 100 to 200 cubic feet per minute (cfm) of air. A typical house needs maybe 50 cfm (depending on which ventilation standard you go by). What many designers do is set the ERV to run intermittently, say 20 minutes out of each hour, to meet the ventilation needs of the house.
What are the excitation and emission wavelengths for GFP S65T?
This GFP variant had the longest-wavelength excitation maximum yet described, 504 nm, as compared with 490 nm for S65T (Table 1).
How is GFP fluorescence measured?
Flow cytometry and fluorescent microscopy are two conventional tools to detect the GFP signal; flow cytometry is an effective and sensitive technique to quantitatively analyze fluorescent intensity, while fluorescent microscopy can visualize the subcellular location and expression of GFP.
How many kDa is GFP?
27 kDa
The green fluorescent protein (GFP), originally discovered in the jellyfish, Aequorea victoria, is composed of 238 amino acids and has a molecular weight of 27 kDa.
Does ERV dehumidify?
ERV’s do not remove additional moisture ERVs are not designed to remove moisture; they do not include settings to maintain and control relative humidity or even include drainage for collected condensate. Since the exchange of water vapor between the two airstreams is not equal, an ERV will raise indoor humidity.
How long does an ERV last?
ERVs have a warranty of around two years and will last over 20 years if properly maintained. An HRV system, on the other hand, typically has a lifespan of 10–15 years. You can increase the lifespan of either type by taking good care of its fans, vents, ventilation core, filters, and other components.
How much should ERV run?
Which of the following is the peak most intense absorption wavelength for GFP?
victoria has a major excitation peak at a wavelength of 395 nm and a minor one at 475 nm. Its emission peak is at 509 nm, which is in the lower green portion of the visible spectrum. The fluorescence quantum yield (QY) of GFP is 0.79….Green fluorescent protein.
| Available protein structures: | |
|---|---|
| PDBsum | structure summary |
How is GFP concentration measured?
The quantity of GFP is determined by comparing its fluorescence with that of GFP standard. The kit can detect a wide range of GFP concentration (0.01-10 µg/ml). A GFP quench solution is also provided for determining auto-fluorescence of cell or tissue extracts.
What is the MW of GFP?
One interesting candidate gene that fulfills these requirements is the gene-encoding green fluorescent protein (GFP). It was originally isolated from the jellyfish Aquorea victoria. The GFP cDNA consists of 730 bp, which encode a 238 amino acid protein with a molecular weight of 27 kD (2).
What is the size of green fluorescent protein?
GFP is big GFP is a 28 kDa protein that resembles a cylinder with a length of 4.2 nm and a diameter of about 2.4 nm (Hink et al., 2000). The complete beta-barrel is necessary for its fluorescence and therefore GFP cannot be downsized by deleting residues.