How do you check the codes on a 1993 Honda Accord?

How do you check the codes on a 1993 Honda Accord?

To pull the trouble codes from your 1990 through 1993 Honda Accord you’ll need to access the two wire ECU connector located near the passenger side kick panel. You will find a blue connector with one red wire and one green. You will need to insert a paperclip of metal wire between the two prongs.

How do you reset the emission light on a Honda Accord?

Answer provided by

  1. Hold down the odometer trip reset button.
  2. While you’re pressing the button, turn your ignition to the ON position.
  3. Release the odometer reset button.
  4. Your check engine light should turn off.

How do you pull the code on a 1994 Honda Accord?

You can retrieve your Honda Accord’s trouble code(s) yourself by using inserting a jumper wire at the diagnostic connector located in the passenger side kick panel. Insert the jumper wire in the 2 PIN service connector between pins 1 and 2. You should also see a 3 PIN connecter. This is used for a trouble code scanner.

How do you reset Honda warning lights?

On the top left corner of your infotainment screen, press Home and then Settings. Press Vehicle. Then, select Maintenance Info. From here, press Select Reset Items, which will allow you to select which dashboard lights you would like to reset.

How do you reset the check engine light on a Honda?

How to Reset Honda Check Engine Light

  1. Turn off the ignition.
  2. Locate the negative terminal.
  3. Loosen the nut on the negative terminal with a wrench.
  4. Reconnect the negative cable and tighten it back up with your wrench.
  5. This should reset the check engine light for your Honda car.

What causes a Honda Accord to misfire?

Common reasons for this to happen: Faulty spark plugs or wires. Faulty ignition coil. Broken piston rings. Burnt or bent valves.

What is a maintenance code for Honda Accord?

Honda Service Sub-Codes

Sub-Code What it Means
2 Check and potentially replace the air cleaner element, drive belt, dust filter, and pollen filter.
3 If equipped, replace the transmission fluid and transfer fluid.
4 Check and potentially replace spark plugs, timing belt (if equipped), water pump, and valves.

How do I reset my Honda Service Code?

This method should work on any Honda trim model that has a touch screen with a home screen.

  1. Press home.
  2. Select settings.
  3. Press vehicle settings.
  4. Scroll down to maintenance info and press it to select it.
  5. Press reset.
  6. A screen will pop up asking if you really want to reset it or cancel. press reset and that should do it.

How do you unlock the audio system on a Honda Accord?

Thankfully, entering the code is the easy part. Enter the code using the radio preset buttons. So, if your Honda Accord audio system code is “33351,” you would press “3” three times, “5” once, and “1” once. This should unlock and reset your car’s audio system.

What does the p0305 code on a Honda Accord mean?

P0305 is a fairly common trouble code with the Honda Accord. It’s and OBD2 code and stands for: P0305 is certainly a cause for concern, and should be considered a threat to the drivability your Accord.

What are the ACORD standards?

Rules and guides relevant across all Standards, including Naming & Design, DRI, AMS SOAP, and more. ACORD facilitates an open Standards development process. Changes to the ACORD Standards are proposed, presented for review, and voted on by members.

How do I find the radio code on my Honda Accord?

There are a few ways to retrieve your Honda Accord’s radio code: Look inside your glovebox or owner’s manual for the code. You’ll find it on a sticker with the radio serial number. Visit our Honda service center at Fisher Honda near Denver.